-
New
- Current Inventory
- Arctic
- Boxer
-
Echo
- Accessories
- Augers & Engine Drills
- Axes
- Bed Redefiners
- Blowers
- ChainSaws
- Chipper/Shredders
- Cut-Off Saws
- Edgers
- Fire Pump
- Generators/Inverters
- Hand Pruners
- Hedge Shears
- Hedge Trimmers
- Loppers
- Lawn Mowers
- Power Pruners
- Pressure Washers
- Pro Attachment Series
- Splitting Wedge
- Sprayers
- Spreaders
- Trimmers & Brushcutters
- Tillers/Cultivators
- Wheeled Trimmers
- Combo Kits
- Exmark
- EZ Link Arms
- Fecon
- Generac
- Husqvarna
- Hyundai Construction
- Kage
- Kubota
- Land Pride
- Orec
- Mi-T-M
- Paladin Attachments
- SnowEx
- Sno-Way
- Virnig
- Used
- Specials
- Departments
- Rentals
- Our Company
-
New
-
Echo
- Accessories
- Augers & Engine Drills
- Axes
- Bed Redefiners
- Blowers
- ChainSaws
- Chipper/Shredders
- Cut-Off Saws
- Edgers
- Fire Pump
- Generators/Inverters
- Hand Pruners
- Hedge Shears
- Hedge Trimmers
- Loppers
- Lawn Mowers
- Power Pruners
- Pressure Washers
- Pro Attachment Series
- Splitting Wedge
- Sprayers
- Spreaders
- Trimmers & Brushcutters
- Tillers/Cultivators
- Wheeled Trimmers
- Combo Kits
-
Used
- Specials
-
Departments
- Rentals
-
Our Company
Kubota Seasonal Tips
SEASONAL STORAGE TIPS
SHORT-TERM MACHINE STORAGE
- Keep the machine and supply of fuel in locked storage and remove the ignition key to prevent children, or others, from playing or tampering with them.
- To avoid sparks from an accidental short circuit, always disconnect the battery's ground cable (negative terminal) first and reconnect it last.
- Do not store the machine with fuel in the tank inside a building where fumes may ignite. Turn the fuel shut-off valve to the "closed" position (if equipped). Drain all fuel from tank and carburetor (if equipped). Allow the engine to cool before storing.
- To avoid the danger of exhaust fume poisoning, do not operate the engine in a closed building without adequate ventilation.
- To reduce fire hazards, clean the machine thoroughly before storage. Dry grass and leaves around the engine and mufflers may ignite.
LONG-TERM MACHINE STORAGE
If you intend to store your machine for an extended period of time, follow the procedures outlined below. These procedures will ensure the machine is ready to operate with minimum preparation when it is removed from storage.
- Check for loose bolts and nuts and tighten, if necessary.
- Apply grease to machine areas where bare metal will rust. Also, apply grease to pivot areas.
- Inflate the tires to a pressure a little higher than usual.
- Change the engine oil and run the engine for about five minutes to circulate oil throughout the engine block and internal moving parts.
- With all implements lowered to the ground, coat any exposed hydraulic cylinder piston rods with grease.
- Remove the battery from the machine. Store the battery following the battery storage procedures.
- Keep the machine in a dry place and sheltered from rain. Cover the machine.
- Store the machine indoors in a dry area protected from sunlight and excessive heat. If the machine must be stored outdoors, cover it with a waterproof tarpaulin.
- Jack the machine up and place blocks under the front and rear axles so that all four tires are off the ground. Keep the tires out of direct sunlight and extreme heat.
Important: When washing the machine, be sure to stop the engine and allow sufficient time for the engine to cool before washing. Cover the machine after the muffler and engine have cooled down.
REMOVING THE MACHINE FROM STORAGE
- Check the tire air pressure and inflate the tires if they are low.
- Jack the machine up and remove the support blocks.
- Install the battery. Before installing the battery, make sure it is fully charged.
- Check the fan belt tension.
- Check all fluid levels (engine oil, transmission/hydraulic oil, engine coolant and any attached implements).
- Start the engine. Observe all gauges. If all gauges are functioning properly and reading normal, move the machine outside.
- Once outside, park the machine and let the engine idle for at least five minutes.
- Shut the engine off and walk around machine and make a visual inspection looking for evidence of oil or water leaks.
- With the engine fully warmed up, release the parking brake and test the brakes for proper adjustment as you move forward. Adjust the brakes as necessary.
CAUTION! To avoid personal injury: Do not clean the machine with engine running. To avoid the danger of exhaust fume poisoning, do not operate the engine in a closed building without proper ventilation. When storing, remove the key from the key switch to avoid unauthorized persons from operating the machine and getting injured.
New Products
Used Equipment
Contact Us
-
2001 5th St. Suite 40
Silvis, IL 61282Phone: 309.751.4661
Fax: 309.751.4388Saturday : Closed all daySunday : Closed all dayMonday : 7:30am to 5:30pmTuesday : 7:30am to 5:30pm- Christmas Eve: Closed all dayWednesday : 7:30am to 5:30pm- Christmas: Closed all dayThursday : 7:30am to 5:30pmFriday : 7:30am to 5:30pm
© Copyright 2022 | All Rights Reserved. Site by EquipmentLocator.com